Monthly Archives: October 2018

At the 2018 NRG Conference

The 2018 Nautical Research Guild Conference is in progress and I’ve been here manning a vendor table for Ages of Sail. I’m not thrilled with being in Las Vegas, just not my thing, but I’ve managed to get by. The event is being held at the Palace Station Hotel and Casino, and located on the second floor.

The event is lightly attended, but the those here seem to be enjoying the talks and workshop round tables. There are only two other vendors here besides Ages of Sail, so the table gets extra attention. Makes time pass more quickly.

Sherline lathe demonstration

Continue reading

Advertisement

Building Woody Joe’s Horyu-ji Temple Five-Story Pagoda – Part 3

With the construction of the base of the temple completed, I proceeded to paint the completed assembly using smokey beige satin-finish Rust-Oleum Ultra Cover spray paint. I also decided to go forward with construction of the mounting base. This was actually from Step 27 in the instructions, but I had the parts out and didn’t see any reason not to go ahead with this assembly.

The base of the pagoda painted a stoney gray color. If I wanted to get more authentic, I would have painted it earlier in construction and masked off areas to create different shading for the different stone blocks.

Continue reading

Japanese Diorama Products Now Available from Zootoyz

Just saw that the online Japanese hobby store, Zootoyz.com, has just added Woody Joe diorama products.

[Note: This was announced on Zootoyz’s Facebook page, but there is currently no link on the website itself. Until the site’s navigation is updated, here’s a link to the new products: https://www.japan-wooden-model-kits-zootoyz.shop/contents/en-us/d2045761143_Diorama-products-by-Woody-JOE.html]

This line of products includes sakura, cherry blossom trees, Japanese pines, cypress trees, box trees, cedar trees, generic broadleaf and conifer trees and other vegetation. There are also bags of ground cover for simulating grass, dirt, and gravel.

Continue reading

Building a Beginning Billing Boats Kit, Dana Fishing Boat – Part 3

After doing all that deck work and planking, the hull work was a nice little change of pace. This kit features an ABS plastic hull that’s been vacuum-formed. It’s a bit different than working with traditional styrene plastic kits. Vacuum-formed parts usually require some trimming, which is true in the case of this kit.

The hull itself is one piece, with the deck and deck houses being part of the second half of the hull assembly. Along the edge where the hull pieces meet, the edge is oversized and needs to be trimmed even. I used a drafting compass to check the evenness of the work, trimming with a knife and finishing with a sanding stick.

Continue reading