The latest on Le Petit Galère from Paris’ Le Souvenirs de Marine. The major hull detail are wrapped up here as I’m getting closer to laying down some paint on the model.
So, I drilled out the rogui on which the ro, or sculling oars, pivot. I used a sharp point to start the hole and finished up using a small drill in a Dremel rotary tool. Because I’m starting to consider painting the model, I’m going to hold off on adding the pins to the rogui until some later time.
Also, I found more structural work to complete before I have to deal with the rails, so I’m putting that assembly off for the moment.
Finishing Mortises
Today, I finished the remaining mortises. I did these the same way as the ones done earlier, laying out strips of tape to maintain even spacing, but the mortises at the todate (transom) and the miyoshi (stem), were a little smaller and slightly closer together.
View original post 430 more words